When your belt gives out, it can be a major inconvenience. But don’t worry, it’s a relatively easy fix that anyone can do with the right tools and a little bit of patience.
Image: www.reddit.com
Step 1: Gather Your Tools
You will need:
- A new belt
- A screwdriver
- A hammer
- A nail or punch
- A piece of scrap wood
Step 2: Remove the Old Belt
Use the screwdriver to remove the screws that hold the old belt in place. Once the screws are removed, you can pull the old belt off.
Step 3: Prepare the New Belt
Measure the new belt against the old belt to make sure it is the correct length. If the new belt is too long, you can cut it to the correct length using a sharp knife.
Image: www.youtube.com
Step 4: Attach the New Belt
Place the new belt over the pulley and align the holes. Insert the screws into the holes and tighten them using the screwdriver.
Step 5: Test the Belt
Once the belt is attached, turn on the machine and let it run for a few minutes. Check to make sure that the belt is running smoothly and that there is no vibration.
Step 6: Adjust the Belt Tension
If the belt is too loose, it will slip and cause the machine to lose power. If the belt is too tight, it will put strain on the bearings and could cause the machine to overheat.
To adjust the belt tension, loosen the screws that hold the motor in place. Move the motor until the belt is taut but not too tight. Tighten the screws to hold the motor in place.
Step 7: Finish Up
Once the belt is adjusted, turn off the machine and let it cool down. Check to make sure that all of the screws are tight and that the belt is running smoothly.
How To Fix Broken Belt
Fixing a Broken Belt is Easy with the Right Tools and a Little Patience
If you follow these steps, you should be able to fix a broken belt in no time. Be sure to follow all of the safety instructions and use caution when working with tools. If you are not comfortable fixing the belt yourself, you can always take it to a mechanic.
