Want to delve deeper into How To Restart The Pilot Light On A Water Heater? Read this article to gain broader knowledge.
I once had a cold shower on a freezing winter morning because my water heater’s pilot light had gone out. I fumbled around in the dark, trying to relight it, but to no avail. I was about to give up and call a plumber when I finally managed to get it going. Since then, I’ve learned how to restart a pilot light safely and effectively, and I’m sharing my knowledge with you today.
How To Restart The Pilot Light On A Water Heater
Water heaters use natural gas or propane to heat the water in your home. A pilot light is a small flame that burns continuously to ignite the main burner when you turn on hot water. If the pilot light goes out, you’ll have no hot water.
Igniting the Pilot Light
To relight the pilot light, you will need a long lighter or matches. If you don’t have a long lighter, you can use a regular lighter and a piece of wire or a coat hanger. Before you begin, make sure the gas supply to the water heater is turned on.
1. Locate the pilot light assembly. It is usually located at the bottom of the water heater.
2. Turn the gas control knob to the “pilot” setting. This will allow gas to flow to the pilot light.
3. Push the reset button. This will open the gas valve and allow gas to flow to the pilot light.
4. Hold the lighter or match to the pilot light. Keep it there for about 30 seconds, or until the pilot light stays lit on its own.
5. Release the reset button. The pilot light should stay lit.
6. Turn the gas control knob to the “on” setting. This will allow gas to flow to the main burner and heat the water.
If the pilot light does not stay lit, repeat steps 2-5. If the pilot light still does not stay lit, there may be a problem with the thermocouple or the gas valve. You should call a qualified technician to repair it.
Tips and Expert Advice
Here are a few tips and expert advice for restarting the pilot light on your water heater:
- If you have a water heater with an electronic ignition system, you may not need to use a lighter or match to ignite the pilot light. Simply follow the instructions in your owner’s manual.
- If you have tried several times to light the pilot light and it still won’t stay lit, there may be a problem with the thermocouple or the gas valve. You should call a qualified technician to repair it.
- If you smell gas, do not attempt to light the pilot light. Call a qualified technician immediately.
FAQs
Q: Why did my pilot light go out?
A: There are several reasons why a pilot light can go out, including drafts, power outages, and gas leaks.
Q: How often should I check my pilot light?
A: It is a good idea to check your pilot light once a month to make sure it is still lit. If the pilot light is out, you can follow the instructions above to relight it.
Q: What should I do if I smell gas?
A: If you smell gas, do not attempt to light the pilot light. Call a qualified technician immediately.
Conclusion
Restarting the pilot light on a water heater is a relatively simple task that you can do yourself. By following the steps outlined in this article, you can get your hot water back up and running in no time.
Are you interested in learning more about water heaters? Check out our other articles on the topic.
How To Restart The Pilot Light On A Water Heater
Image: www.youtube.com
How To Restart The Pilot Light On A Water Heater has been read by you on our site. We express our gratitude for your visit, and we hope this article is beneficial for you.
